10″ × 4.5″ Whole-House Replacement Filter Pack
Better-tasting water. Less scale. Your 3-Stage system, refreshed.
Refresh your compatible 10″ × 4.5″ system with polyspun sediment, CTO carbon and resin cartridges. A compact replacement set for everyday particles, chlorine taste and unwanted hard water scale.
Who this pack is for
Triple 10" x 4.5" Systems - Time for fresh filters.
When did you last replace your filters? A fresh set helps restore better taste, reduce chlorine smell and keep scale more manageable.
Replace cartridges every 6–12 months, depending on water quality and use. Check sooner if flow drops or taste and odour return.
Better taste
Chlorine taste can get in the way of a glass of water or your first cup of tea. The carbon stage helps reduce it, for better-tasting drinks at home.
From your morning coffee to your evening cuppa.
Fresher showers
The carbon stage helps reduce chlorine and its smell throughout your home, bringing fresher water to your daily shower and skin and hair care routine.
For showers, baths and everyday comfort.
Less scale
The resin stage targets hardness minerals behind recurring white marks on taps, shower glass and appliances.
For homes dealing with calcium-related build-up.
What's in the pack
A compact set for sediment and taste.
Three replacement cartridges supplied together for a compatible 10″ × 4.5″ system. Match each cartridge to its existing housing position before fitting.
Stage 011 Micron PP Sediment Filter — 10″ × 4.5″
Polyspun sediment media catches dirt, sand and rust from the incoming water.
Stage 025 Micron CTO Carbon Block Filter — 10″ × 4.5″
The carbon block targets chlorine taste, odour and other adsorbable compounds.
Stage 03Pleated Sediment Replacement Filter — 10″ × 4.5″, 5 Micron
The pleated cartridge provides another sediment-filtering surface in this supplied set.
Measure these two.
Measure the cartridge you're replacing, not its housing.
Will it fit?
Match your 10″ × 4.5″ cartridges.
Measure the cartridges already fitted, then compare their ends and seals. Housing dimensions alone do not confirm cartridge compatibility.
Measured it and still not sure?
Send a photo of the cartridge beside a tape measure and we'll tell you which size it is.
Call 1300 264 173 or email sales@homefiltrationsystems.com.
Nominal sizes vary a little between makers, so match the measurement rather than the label. What we can't tell you is how ours compares to a cartridge we didn't make and haven't tested, or whether a replacement affects your housing's own warranty; that one is between you and its manufacturer.
Fitting it, what comes out, and when it's due again
Cartridge installation & replacement guide
Need help with the change? Call 1300 264 173.
What happens, in order
-
Turn off & release pressureShut off the supply and release pressure through a downstream tap or the relief button, if fitted.
-
Remove & cleanRemove the old cartridges, wash and rinse the bowls, and inspect the seals. Replace damaged O-rings.
-
Fit the replacementsMatch each replacement to the correct existing position. Centre it in the bowl and hand-tighten without overtightening.
-
Flush & checkRestore supply slowly with a downstream tap open. Follow the stated flushing time, then check housings and connections for leaks.
Reviews
What people who fitted it said.
Only buyers we can match to an order can leave one, so the count is lower than it would be otherwise.
FAQ
Questions about this replacement pack?
A few practical answers before you order or change your filters.
How do I know it will fit?
When should I replace the filters?
Do all the filters need changing together?
Does this set reduce hardness or scale?
Can I change them myself?
What if I order the wrong format?
Need a different size or treatment?
Choose the format and filtration purpose that match your water and existing setup.