Year 2 Triple Whole-House UV Replacement Pack — 20″ × 4.5″
A fresh start for your three-stage UV filtration.
Keep your compatible three-cartridge whole-house UV setup on its service schedule. This Year 2 pack combines pleated sediment, PP sediment and nano-silver carbon cartridges with a replacement UV lamp and the pictured sleeve and seals for the service.
Who this pack is for
Year 2 replacements for your 3-stage UV system.
Refresh all three cartridges to help reduce sediment, unwanted taste and odour. Replace the matched UV lamp and quartz sleeve to help maintain UV disinfection.
Replace cartridges every 6–12 months, depending on water quality and use. Check sooner if flow drops or taste and odour return. Follow your UV unit’s separate lamp-replacement schedule.
Keep UV disinfection working
A replacement lamp and clear quartz sleeve help maintain the UV light used to inactivate bacteria after filtration.
For homes treating tank water with UV.
Less tank grit
The pleated and polyspun stages catch particles from stored rainwater before they reach the carbon cartridge.
For homes dealing with roof-and-tank sediment.
Silver protection
Nano-silver technology helps inhibit bacterial growth within the filter media alongside fine particulate filtration.
For the extra function in your carbon stage.
What's in the pack
What arrives in your replacement pack.
Stage 01Pleated Sediment Replacement Filter — 20″ × 4.5″, 5 Micron
The pleated sediment cartridge catches sand, dirt and rust before the finer stages.
Stage 025 Micron PP Sediment Filter — 20″ × 4.5″
The polypropylene sediment cartridge captures particles before they reach the carbon and resin stages.
Stage 031 Micron Nano-silver Carbon Block Filter — 20″ × 4.5″
Carbon helps reduce chlorine taste and odour. Its 1 micron rating captures fine particles, while nano silver helps inhibit bacterial growth in the filter media.
Measure these two.
Measure the cartridge you're replacing, not its housing.
Will it fit?
Match the cartridge format and the working parts.
Compare your current filters’ length, diameter, end openings and seals. A matching nominal size is a starting point; confirm the complete fit with HFS before ordering.
Measured it and still not sure?
Send a photo of the cartridge beside a tape measure and we'll tell you which size it is.
Call 1300 264 173 or email sales@homefiltrationsystems.com.
Nominal sizes vary a little between makers, so match the measurement rather than the label. What we can't tell you is how ours compares to a cartridge we didn't make and haven't tested, or whether a replacement affects your housing's own warranty; that one is between you and its manufacturer.
Fitting it, what comes out, and when it's due again
Plan the cartridge and UV service together.
Need help with the change? Call 1300 264 173.
What happens, in order
-
Identify & isolateCheck the exact replacements against your system guide. Isolate water, release pressure and isolate UV power as directed.
-
Remove & inspectRemove the old cartridges. Clean the housings and check seals; have the UV lamp/sleeve serviced according to the manufacturer’s instructions.
-
Fit the matched partsSeat each cartridge in its specified position. Match UV connectors and seals exactly, and arrange qualified help for the UV service if needed.
-
Restore, flush & checkRestore supply as directed, flush the cartridges and inspect for leaks. Confirm normal UV status before returning the system to service. Record the change date.
Reviews
What people who fitted it said.
Only buyers we can match to an order can leave one, so the count is lower than it would be otherwise.